Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
Using DeviceManager to Connect to the IOLAN
86 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0
Using DeviceManager to Connect to the IOLAN
DeviceManager can connect to existing IOLANs or assign an IP address to a new IOLAN. Whenever
you connect to the IOLAN through the DeviceManager, you connect as the Admin user and must
supply the password for the Admin user.
Starting a New Session
To start a new session and connect to the IOLAN using the DeviceManager:
1. Start the DeviceManager by selecting Start, All Programs, Perle, DeviceManager,
DeviceManager.
2. When the DeviceManager starts, it searches the network for IOLANs.
Note:
If you are not seeing IPv6 addresses in the list (you must expand the entry), see IPv6
Issues on page 416 to find out how to install IPv6 support.
If your IOLAN is not in the local network and you do not have a multicast enabled router in your
network and therefore is not displayed in the selectable list, but can be pinged from your PC, you
can add it to the selectable list by clicking the
Add button.
Click the Add button and type in the IOLAN’s IP address; this field supports IPv4 and IPv6
addresses. Click the
Close button when you have completed adding all the manual entries. Select
the manually added server to connect to it.