Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
Serial Pinouts
368 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0
RJ45 (for SDS32C/SDS16C/SDS8C Electric Utility models)
This section defines the pinouts for the RJ45 connection for the Electric Utility models. The serial
ports can be set to operate in EIA-232, EIA-422 or EIA-485 mode. The table provides the pinout for
each of the modes of operation. The console port is an EIA-232 dedicated port. It’s pinout is detailed
in a separte table below.
Pin 1
Pin 8
The following table provides pinout information for the seial ports:
Pin#
EIA-232
EIA-422
EIA-485
Full Duplex
EIA-485
Half Duplex
1 RTS (out) TxD+ TxD+ DATA+
2 DTR(out)
3 TxD (out) TxD- TxD- DATA-
4 GND GND GND GND
5 GND GND GND GND
6 RxD (in) RxD+ RxD+
7 DSR (in)
8 CTS (in) RxD- RxD-
The following table provides pinout information for the console port
Pinout
8-pin
EIA-232
Admin Port
1 DCD (in)
2 RTS (out)
3 DSR (in)
4 TxD (out)
5 RxD (in)
6 GND
7 CTS (in)
8 DTR (out)