Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
RADIUS and TACACS+ 351
RADIUS
Mapped RADIUS Parameters to IOLAN Parameters
When authentication is being done by RADIUS, there are several Serial Port and User parameters
that can be set by the RADIUS server. Any parameters sent by that RADIUS server that are not
supported by the IOLAN are discarded. Below is a list of the RADIUS parameters and their IOLAN
parameters:
Service-Type This has no IOLAN field, although it needs
to be set to
Framed-User in the RADIUS
server.
Framed-Protocol Set to SLIP or PPP service.
Framed-Address Remote IP Address field under either SLIP
or PPP.
Caution: the exception to the above rule is
a
Framed-Address value of
255.255.255.254. When this value is
specified in the RADIUS file, the unit will
use the Remote IP address configured for a
PPP line in the IOLAN.
Framed-Netmask IPv4 Subnet Mask field under either SLIP
or
PPP.
Framed-Compression VJ Compression field under either SLIP or
PPP.
Framed-MTU MTU field under SLIP.
MRU field under PPP.
Idle-Timeout Idle Timeout under the serial port
Advanced settings.
Login-Service Corresponds to one of the following User
Service
parameters: Telnet, Rlogin, TCP
Clear, SSH, or SSL Raw.
Session-Timeout Session Timeout under the serial port
Advanced settings.
Callback-Number Combination of the Enable Callback and
Phone Number fields under User,
Advanced settings.
Callback-ID Combination of the Enable Callback and
Phone Number fields under User,
Advanced settings.
RADIUS Parameter IOLAN Parameter