Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0 347
RADIUS and TACACS+ Appendix A
A
Introduction
This chapter describes the parameters that can be passed to the IOLAN when a user logs into the
IOLAN (serial port set to profile
Terminal) from external authentication RADIUS and TACACS+
servers.
RADIUS
Although RADIUS can be used strictly for external authentication, it can also be used to configure
line and user parameters. Therefore, when a user is being authenticated using RADIUS, it is possible
that the user’s configuration is a compilation of the parameters passed back from RADIUS, the
IOLAN parameters if the user has also been set up as a local user in the IOLAN, and the Default
User’s parameters for any parameters that have not been set by either RADIUS or the user’s local
configuration.
Supported RADIUS Parameters
This section describes the attributes which will be accepted by the IOLAN from a RADIUS server in
response to an authentication request.
Type Name Description
1 User-Name The name of the user to be authenticated.
2 User-Password The password of the user to be authenticated.