Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0 313
Controlling the RPS, I/O
Channels, and IPsec
Tunnels Chapter 14
14
Introduction
The Control section appears when the IOLAN is connected to a Remote Power Switch and/or an I/O
model or you want to control the IPsec tunnel.
RPS Control
Overview
When a Remote Power Switch’s (RPS) console port is attached to the IOLAN’s serial port and the
serial port is configured for the Power Management profile, you will be able to control the RPS’s
power plugs either universally or individually (power on/off the whole RPS or individual plugs).
Field Descriptions
The following buttons are available:
On Button
Off Button
Cycle Button
Reset to Default
State Button
Plug Control Button
Turns all the RPS plugs on.
Turns all the RPS plugs off.
Turns all the RPS plugs off and then on.
Resets all the RPS plugs to the default state as configured in the Power
Management
profile settings.
Displays a window that allows you to manage the individual plugs on the RPS.