Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
249
Settings
Failsafe Timer Functionality
Overview
The Failsafe Timer tab configures the I/O failsafe timer. The Failsafe Timer is enabled on a global
basis and provides a trigger mechanism that can be configured for each channel when no I/O
traffic/management has occurred for the specified amount of time. A Failsafe Action can be
configured for each Digital Output channel, each Serial Signal Output pin (DTR and RTS), and each
Relay channel to either Activate or Deactivate the output.
The Failsafe Timer has a different function when I/O Extension is enabled for Digital Output
channels, Relay channels, or the Serial Signal Output pins (DTR and RTS). For I/O Extension, the
Failsafe Timer provides a per channel or per serial signal output pin trigger mechanism that is
activated when there are no TCP sessions for the specified amount of time.
Field Descriptions
Configure the following parameters:
Enable I/O Failsafe
Timer
Timeout
Enables/disables the Failsafe Timer. This is the global setting that must be
enabled to set the Failsafe Action on the channel for digital output and relay
channels or output signal pins. When this timer expires because of no I/O
activity within the specified time interval, the Failsafe Action set for the
channel determines the action on the output. When the channel or serial signal
pin is configured for I/O extension, the timer expires there are no TCP sessions
for the specified time interval.
Default: Disabled
The number of seconds that must elapse before the channel/serial signal pin
Failsafe Action is triggered.
Range: 1-9999
Default: 30 seconds