Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
241
Services
DeviceManager DeviceManager daemon process in the IOLAN. If you disable this service, you
will not be able to connect to the IOLAN with the DeviceManager application.
The DeviceManager listens on port 33812 and sends on port 33813.
Default: Enabled
WebManager
(HTTP)
WebManager daemon process in the IOLAN listening on port 80.
Default: Enabled
WebManager
(HTTPS)
Secure WebManager daemon process in the IOLAN listening on port 443.
Default: Enabled
If you are using the WebManager in secure mode (HTTPS), you need to
download the SSL/TLS private key and certificate to the IOLAN. You also
need to set the
SSL Passphrase parameter with the same password that was
used to generate the key. See Keys and Certificates on page 242 for more
information.
SSH Server SSH daemon process in the IOLAN listening on TCP port 22.
Default: Enabled
SNTP Client Simple Network Time Protocol client process in the IOLAN.
Default: Enabled
Dynamic Routing
(RIP)
Dynamic Routing daemon process in the IOLAN listening on port 520.
Default: Enabled
IPsec IPsec daemon process in the IOLAN listening and sending on UDP port 500.
Default: Disabled