Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
VPN
232 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0
IKE Phase 1 Proposals
The following IKE Phase 1 proposals are supported by the IOLAN VPN gateway:
z Ciphers—3DES, AES
z Hashes—MD5, SHA1
z Diffie-Hellman Groups—2 (MODP1024), 5 (MODP1536), 14 (MODP2048), 15 (MODP3072),
16 (MODP4096), 17 (MODP6144), 18 (MODP8192)
ESP Phase 2 Proposals
The following ESP Phase 2 proposals are supported by the IOLAN VPN gateway:
z Ciphers—3DES, AES
z Authentication Algorithms—MD5, SHA1, SHA2
IPsec
When an IPsec tunnel becomes active, you are requiring that all access to the IOLAN go through the
configured IPsec tunnel(s), so you must configure any exceptions first (see
Exceptions on page 238
for more information on exceptions) or you will not be able to access the IOLAN through the
network unless you are configured to go through the IPsec tunnel (you can still access the IOLAN
through the Console port).
Field Descriptions
The following buttons are available:
Add Button
Edit Button
Delete Button
Click this button to add a new IPsec VPN tunnel.
Select an existing IPsec VPN tunnel to edit the tunnel’s parameters.
Select an existing IPsec VPN tunnel to remove the tunnel.