Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
225
SSH
Field Descriptions
Configure the following parameters:
Allow SSH-1
Protocol
Allows the user’s client to negotiate an SSH-1 connection, in addition to SSH-
2.
Default: Disabled
RSA When a client SSH session requests RSA authentication, the IOLAN’s SSH
server will authenticate the user via RSA.
Default: Enabled
DSA When a client SSH session requests DSA authentication, the IOLAN’s SSH
server will authenticate the user via DSA.
Default: Enabled
Keyboard-
Interactive
The user types in a password for authentication.
Default: Enabled
Password The user types in a password for authentication.
Default: Enabled
3DES The IOLAN SSH server’s 3DES encryption is enabled/disabled.
Default: Enabled
CAST The IOLAN SSH server’s CAST encryption is enabled/disabled.
Default: Enabled
Blowfish The IOLAN SSH server’s Blowfish encryption is enabled/disabled.
Default: Enabled
Arcfour The IOLAN SSH server’s Arcfour encryption is enabled/disabled.
Default: Enabled
AES The IOLAN SSH server’s AES encryption is enabled/disabled.
Default: Enabled