Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
221
Authentication
SecurID
Overview
If you need to reset the SecurID secret, select Tools, Reset, Reset SecurID Node Secret.
Field Descriptions
Configure the following parameters:
Primary/Master
Host
Replica/Slave Host
UDP Port
Encryption Type
s
Legacy
Accounting
Secondary Host
The secondary TACACS+ host that is used for accounting, should the primary
accounting TACACS+ host fail to respond.
Default: None
Accounting Port The port number that TACACS+ listens to for accounting requests.
Default: 49
Accounting Secret The TACACS+ shared secret is used to encrypt/decrypt TACACS+ packets in
communications between two devices. The shared secret may be any
alphanumeric string. Each shared secret must be configured on both client and
server sides.
The first SecurID server that is tried for user authentication.
Default: None
If the first SecurID server does not respond to an authentication request, this is
the next SecurID server that is tried for user authentication.
Default: None
The port number that SecurID listens to for authentication requests.
Default: 5500
The type of encryption that will be used for SecurID server communication.
Data Options: DES, SDI
Default: SDI
If you are running SecurID 3.x or 4.x, you need to run in Legacy Mode. If you
are running SecurID 5.x or above, do not select
Legacy Mode.
Default: Disabled