Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
217
Authentication
Attributes Field Descriptions
Configure the following parameters:
Account Port The port that the RADIUS host listens to for accounting requests.
Default: 1813
Enable Accounting
Authenticator
Enables/disables whether or not the IOLAN validates the RADIUS accounting
response.
Default: Enabled
Retry The number of times the IOLAN tries to connect to the RADIUS server before
erroring out.
Range: 0-255
Default: 5
Timeout The time, in seconds, that the IOLAN waits to receive a reply after sending out
a request to a RADIUS accounting or authentication host. If no reply is
received before the timeout period expires, the IOLAN will retry the same host
up to and including the number of retry attempts.
Range: 1-255
Default: 3 seconds
NAS-Identifier This is the string that identifies the Network Address Server (NAS) that is
originating the Access-Request to authenticate a user.
Field Format: Maximum 31 characters, including spaces
Automatically
determine NAS-IP-
Address
When enabled, the IOLAN will send the IOLAN’s Ethernet 1 IPv4 address to
the RADIUS server.
Default: Enabled