Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
Serial Port Profiles
130 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0
TruePort Profile
Overview
TruePort is especially useful when you want to improve data security, as you can enable an SSL/TLS
connection between the TruePort host port and the IOLAN. TruePort is COM Port redirector that is
supplied with the IOLAN. TruePort can be installed as a client on a Workstation or Server and
supports a variety of operating systems. It, in conjunction with the IOLAN, emulates a local serial
port (COM port), to the application, to provide connectivity to a remote serial device over the
network. The TruePort profile operates in conjunction with the TruePort software.
Functionality
TruePort is a COM port redirector utility for the IOLAN. It can be run in two modes (these modes
will be set on the client software when it is configured):
z TruePort Full mode—This mode allows complete device control and operates as if the device
was directly connected to the Workstation/Server’s local serial port. It provides a complete COM
port interface between the attached serial device and the network. All serial controls, baud rate
control, etc., are sent to the IOLAN and replicated on its associated serial port.
z TruePort Lite mode—This mode provides a simple raw data interface between the application
and the remote serial port. Although the port will still operate as a COM port, control signals are
ignored. In this mode, the serial communications parameters must be configured on the IOLAN.
See the TruePort User’s Guide for more details about the TruePort client software.
Modem The name of the predefined modem that is used on this line.
Phone The phone number to use when Dial Out is enabled.