Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
Serial Port Profiles
122 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0
EOF1 Character Specifies the End of Frame character, which defines when the frame is ready to
be transmitted. The actual transmission of the frame is based on the Trigger
Forwarding Rule.
Range: Hex 0-FF
Default: 0
EOF2 Character When enabled, creates a sequence of characters that must be received to define
the end of the frame (if the EOF1 character is not immediately followed by the
EOF2 character, the IOLAN waits for another EOF1 character to start the
EOF1/EOF2 character sequence), which defines when the frame is ready to be
transmitted. The actual transmission of the frame is based on the Trigger
Forwarding Rule.
Range: Hex 0-FF
Default: 0
Trigger
Forwarding Rule
Determines what is included in the Frame (based on the EOF1 or EOF1/EOF2)
or Packet (based on Trigger1 or Trigger1/Trigger2). Choose one of the
following options:
z Strip-Trigger—Strips out the EOF1, EOF1/EOF2, Trigger1, or
Trigger1/Trigger2, depending on your settings.
z Trigger—Includes the EOF1, EOF1/EOF2, Trigger1, or
Trigger1/Trigger2, depending on your settings.
z Trigger+1—Includes the EOF1, EOF1/EOF2, Trigger1, or
Trigger1/Trigger2, depending on your settings, plus the first byte that
follows the trigger.
z Trigger+2—Includes the EOF1, EOF1/EOF2, Trigger1, or
Trigger1/Trigger2, depending on your settings, plus the next two bytes
received after the trigger.
Default: Trigger