Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
111
Advanced
Adding/Editing an IPv6 Tunnel
When you add/edit an IPv6 tunnel, you are determining how an IPv6 message will reach an IPv6
device through an IPv4 network.
Configure the following parameters:
Name
Mode
Remote Host
Interface
The name of the IPv6 tunnel.
Field Format: Maximum 16 alphanumeric characters
Default: ipv6_tunnel1
The method or protocol that is used to create the IPv6 tunnel.
z Manual—When enabled, the IOLAN will manually create the IPv6 tunnel
to the specified
Remote Host through the specified Interface.
z 6to4—When enabled, the IOLAN will broadcast to the multicast address
192.88.99.1 through the specified
Interface. When the closest 6to4 router
responds, it will create the IPv6 tunnel, encapsulating and decapsulating
IPv6 traffic sent to and from the IOLAN.
z Teredo—When enabled, the Teredo protocol encapsulates the IPv6 packet
as an IPv4 UDP message, allowing it to pass through most network
address translator (NAT) boxes and create an IPv6 tunnel to the specified
Remote Host (a Teredo server) through the specified Interface.
Default: Manual
The IPv4 host that can access the IPv6 network when the Mode is Manual.
The Teredo server when the
Mode is Teredo.
Default: None
The interface that the IOLAN is going to use to access the Remote Host. The
list is comprised of the Ethernet interface(s) and serial ports configured for the
Remote Access (PPP) or Remote Access (SLIP) profiles.
Default: Ethernet 1