Server User Manual
Table Of Contents
- SDS/SCS/STS/MDC User’s Guide
- Table of Contents
- Preface
- Introduction
- Hardware and Connectivity
- Configuration Methods
- Getting Started
- Using DeviceManager and WebManager
- Network Settings
- Configuring Serial Ports
- Introduction
- Serial Ports
- Serial Port Profiles
- Common Tabs
- Console Management Profile
- TruePort Profile
- TCP Sockets Profile
- UDP Sockets Profile
- Terminal Profile
- User Service Settings
- Printer Profile
- Serial Tunneling Profile
- Virtual Modem Profile
- Control Signal I/O Profile
- Modbus Gateway Profile
- Power Management Profile
- Remote Access (PPP) Profile
- Remote Access (SLIP) Profile
- Custom Application Profile
- Port Buffering
- Advanced
- Configuring Users
- Configuring Security
- Configuring I/O Interfaces
- Configuring Clustering
- Configuring the Option Card
- Configuring the System
- Controlling the RPS, I/O Channels, and IPsec Tunnels
- System Administration
- Introduction
- Managing Configuration Files
- Downloading IOLAN Firmware
- Calibrating I/O
- Setting the IOLAN’s Date and Time
- Rebooting the IOLAN
- Resetting the IOLAN to Factory Defaults
- Resetting the SecurID Node Secret
- Language Support
- Downloading Terminal Definitions
- Resetting Configuration Parameters
- Lost Admin Password
- Applications
- RADIUS and TACACS+
- SSL/TLS Ciphers
- Virtual Modem AT Commands
- Pinouts and Cabling Diagrams
- Setting Jumpers
- I/O Wiring Diagrams
- Utilities
- Accessories
- Troubleshooting
- Introduction
- Hardware Troubleshooting
- Communication Issues
- DeviceManager Problems
- Host Problems
- RADIUS Authentication Problems
- Login Problems
- Problems with Terminals
- Unknown IP Address
- DHCP/BOOTP Problems
- Callback Problems
- Language Problems
- Modem Problems
- PPP Problems
- Printing Problems
- Long Reboot Cycle
- SSL/TLS
- I/O Models
- IPv6 Issues
- Contacting Technical Support
- Glossary
- Index
109
Advanced
Validation Criteria Field Descriptions
If you choose to configure validation criteria, the information in the peer SSL/TLS certificate must
match exactly the information configured in this window in order to pass peer authentication and
create a valid SSL/TLS connection.
Configure the following parameters:
HMAC Select the key-hashing for message authentication method for your encryption
type.
Data Options:
z Any
z MD5
z SHA1
Default: Any
Country A country code; for example, US. This field is case sensitive in order to
successfully match the information in the peer SSL/TLS certificate.
Data Options: Two characters
State/Province An entry for the state/province; for example, IL. This field is case sensitive in
order to successfully match the information in the peer SSL/TLS certificate.
Data Options: Maximum 128 characters
Locality An entry for the location; for example, Chicago. This field is case sensitive in
order to successfully match the information in the peer SSL/TLS certificate.
Data Options: Maximum 128 characters
Organization An entry for the organization; for example, Accounting. This field is case
sensitive in order to successfully match the information in the peer SSL/TLS
certificate.
Data Options: Maximum 64 characters
Organization Unit An entry for the unit in the organization; for example, Payroll. This field is
case sensitive in order to successfully match the information in the peer
SSL/TLS certificate.
Data Options: Maximum 64 characters