Owners manual

P E R L I N I Q U I C K S T A R T G U I D E

Please read instruction manual before using this product, and watch our instructional video at www.perlini.biz.

Questions? Email us at info@perlagesystems.com.

SEE SAFETY PRECAUTIONS ON THE BACK OF THIS QUICK START GUIDE!

1. Install CO

cartridge in the pressurizer

Place a 16-gram Perlage CO

cartridges inside the cup half, with the narrow neck of the cartridge

pointing upwards ( ). Screw the cup onto the body of the pressurizer unit until tight. DO NOT

OVERTIGHTEN.

2. Disassemble Perlini

Unscrew the upper body from the lower body, and remove the cap ( ). Inspect components

for wear or damage. DO NOT USE PRODUCT IF DAMAGED. Make sure the gasket is properly

installed.

3. Mix cocktail and add ice

Mix the ingredients of your cocktail in the lower body as you would with a cocktail shaker, and ﬁ ll

with cubed ice ( ).

Liquids must be ice cold to produce satisfactory carbonation levels. If ice is not used, liquid

ingredients must be pre-chilled.

4. Assemble Perlini

Screw the two halves of the shaker together ﬁ nger tight; screw the cap on ﬁ nger tight ( ).

DO NOT OVERTIGHTEN. Overtightening can damage the components, and make Perlini

difﬁ cult to disassemble. Only ﬁ ngertip pressure is necessary to tighten the cap and upper

body.

5. Pressurize Perlini

Holding the Perlini shaker at a 45-degree angle, press the nozzle of the pressurizer against the

conical oriﬁ ce in the cap, and press the trigger on the handle ( ). Hold the trigger down for

8-10 seconds, or until the gas stops ﬂ owing.

Before shaking the cocktail, verify that you have a good seal by listening for escaping gas.

If you hear gas escaping, slowly remove the cap, and unscrew the two halves to check the

seal.

6. Shake

Shake the pressurized cocktail moderately for 7-10 seconds.

7. Rest

Allow the shaken cocktail to sit for 15-30 seconds to allow the foam and bubbles to die down.

8. Slowly remove cap and serve

SLOWLY open the cap ( ). If it looks like the foam will escape the top the shaker, close the cap

and give the liquid more time to settle down.

Remove the cap and pour the drink directly from the spout through the built-in strainer into the

serving glass ( ).

Separate the two halves of the shaker and remove the cap. Rinse in tap water with each and every

use and set aside to dry.

PAGE 1
P E R L I N I Q U I C K S T A R T G U I D E Please read instruction manual before using this product, and watch our instructional video at www.perlini.biz. SEE SAFETY PRECAUTIONS ON THE BACK OF THIS QUICK START GUIDE! 1. Install CO2 cartridge in the pressurizer Place a 16-gram Perlage CO2 cartridges inside the cup half, with the narrow neck of the cartridge pointing upwards ( ). Screw the cup onto the body of the pressurizer unit until tight. DO NOT OVERTIGHTEN. 2.
PAGE 2
S A F E T Y P R E C A U T I O N S Read this before using your Perlini! The Perlini Cocktail Carbonating System uses high-pressure gas, and the shaker is a pressure vessel. Like any high-pressure gas system, it must be treated with care. Improper use or handling of the Perlini System could result in physical injury. To avoid this risk: ¢ Do not drop or impact the cocktail shaker in any way, as this could cause damage which could lead to failure. ¢ Inspect the shaker before each use.