Instructions / Assembly

Country Style Squirrel-Be-Gone II

Model #338

To Install Hanger:

1. Lift lid to remove.

2. Insert the hanger end with the 3 bends (Fig. 1) into the left side

panel. There are two holes, insert into the upper one. (Fig. 2)

3. Bring the other end of the hanger around the back of the feeder

as shown.

4. Place other hanger end into the single hole found on the right

side panel. (Fig. 3) Important Note: To insert properly, you will

have the hanger in a down position, pointing to the back of the

feeder as shown.

5. While pushing the hanger into the hole, lift the hanger into the

upright position. You will notice the end of the hanger on the

left side panel, springing out from the lower hole as indicated.

(Fig. 4) This will lock the hanger in an upright position.

To Install Weather Vane:

1. Insert bottom shaft of weather vane through top of roof peak.

2. Attach locking key to shaft and secure with screw as shown.

(Fig. 5)

Pg. 1

UNDER

ROOF

ABOVE ROOF

screw

shaft

locking key

WEATHER

VANE PARTS

See our full line of Perky-Pet

birdfeeders and accessories at www.perkypet.com

855-757-5973 | Woodstream Corporation | 69 N. Locust Street Lititz, PA 17543, USA

PAGE 1
Country Style Squirrel-Be-Gone II Model #338 To Install Hanger: 1. Lift lid to remove. 2. Insert the hanger end with the 3 bends (Fig. 1) into the left side panel. There are two holes, insert into the upper one. (Fig. 2) 3. Bring the other end of the hanger around the back of the feeder as shown. 4. Place other hanger end into the single hole found on the right side panel. (Fig. 3) Important Note: To insert properly, you will have the hanger in a down position, pointing to the back of the feeder as shown.
PAGE 2
Country Style Squirrel-Be-Gone II Model #338 To Replace and Lock Weather Vane: 1. Fill your feeder with your favorite seed mix. 2. Place the roof on the feeder base and position roof weather vane as shown (Fig. 6). 3. Gently press down on the weather vane so the locking key inserts into the cross beam inside the feeder. 4. While still pressing down, gently turn the weather vane clockwise, 3/8 of a turn until tight, DO NOT FORCE OR DAMAGE MAY RESULT. Your roof peak should now be locked. (Fig. 7) 6.