Installation Guide
Cat. No. 093900112V Stern Light
Cat. No. 0939DP112V Stern Light
The above lights are for replacement use only on sail or power driven vessels under 20 meters (65.6 ft.) in length, and
operating on a nominal 12 volt system. All previous certifications apply. In order to comply with the ʻ72 COLREGS* and the
U.S. Inland Rules*, the following must be adhered to:
MOUNTING INFORMATION
Read all instructions before proceeding.
1). These instructions show the orientation of the light after
the proper location has been determined. For proper light selection, positioning and
configuration, refer to the A.B.Y.C. Standard A-16*, the ʻ72 COLREGS*,and the U.S. Inland Navigation Rules*.
2). This light is supplied with the proper bulb for operation on a nominal 12 volt system . Use PERKO Cat. No. 0070DP0CLR, 12V, 10W bulb for a 12
volt system (Stern Light Cat. No. 093900112V or 0939DP112V).
3). These Lights are designed to be mounted on a vertical surface that is perpendicular to the centerline of the boat and facing astern.
4). Draw an 8 inch long horizontal reference line through the center of the selected mounting location.
5). Cut out the mounting template below. Tape it on the mounting surface such that the reference line (drawn above) passes through the exact center
of the template.
6). Drill two holes through the template as indicated for the mounting screws.
7). Drill a 2-1/8 inch hole to accommodate socket holder as indicated.
8). Attach supply connections to the light, making sure to wire in accordance with both A.B.Y.C. Standard E-9* and U.S. Coast Guard Safety
Standards for Boat Electrical Systems (33 CFR 183)*
* The above refenced standards can be obtained from:
1). American Boat & Yacht Council, Inc. 2). U.S. Coast Guard
613 Third Street, Suite 10 Washington, D.C. 20593
Annapolis, MD 21403 (or your local C.G. office)
04/19
0939INS1
MOUNTING TEMPLATE
Cat Nos.
093900112V
0939DP112V
PERKO,INC.
16490 N.W. 13th. Avenue
Miami, FL 33169-5707
www.perko.com
FOR
REPLACEMENT
USE ONLY
Visibility: 2nm
Tested By: IMANNA Labs.
Date: 2/4/03
Meets ABYC A-16 (2011)
12V
This is a
3/4” circle in
order to scale
internet
printed
templates