Owner's manual

ManualsBrandsPERKO ManualsLighting1150

16490 N.W. 13th Avenue Miami, FL 33169-5707

Scale: None

Date: 8/24/82

Revised: 12/2/08

Drawn By: D. Beutler

FIG. 1150RE1 AND 1150GE1

PORT AND STARBOARD SIDE NAVIGATION LIGHTS

No. Name of Piece No. Req. Material Size & Spec.

1 Cap & Cable 1 Polycarb. Fig. No. 1105

2 O-Ring Fig. No. 1119 1 Neoprene 4-5/8x4-1/4x1/8

3 Body 1 Brass or 20 GA-.032

Galv. Steel

4 Lens 1 Polycarb. See Note #1

5 Socket Support Stand 1 Brass Fig.No. 034-001PLB

6 Socket 1 See Note #2

7 Socket, Mounting Screws 2 S/S 8-32 x 3/4” R.H.

8 Ground Screw & Nut 1 S/S 8-32 x 3/4” R.H.

9 Packing Nut & Gland Ring 1 Polycarb. for 7/16” Cable

10 Certification Plate 1 Brass

Not Available As Repl Pt.

11 Mounting Bracket 1 Aluminum Fig. No.0143000ALU

Bill of Material

NOTES:

1. Lens - Red - Port Side: Cat. No. 0259001RED

Green - Starboard Side: Cat. No. 0259001GRN

2. Socket - Medium Prefocus: Cat. No. 0347A

3. Weight - 4Lbs. - 9 ozs

For Vessels

20 Meters (65.6 Ft.) to 50 Meters (164.0 Ft.) in Length

Cat. No. Finish Description Visible Visible Reg. Lamp

Arc Miles Watts Cat. No.

1150RE1GAL Galv Steel Red Sidelight 112-1/2° 2 25 0342000CLR

1150RE1PLB Pln Brass Red Sidelight 112-1/2° 2 25 0342000CLR

1150RE1POL Pol Brass Red Sidelight 112-1/2° 2 25 0342000CLR

1150GE1GAL Galv Steel Green Sidelight 112-1/2° 2 25 0342000CLR

1150GE1PLB Pln Brass Green Sidelight 112-1/2° 2 25 0342000CLR

1150GE1POL Pol Brass Green Sidelight 112-1/2° 2 25 0342000CLR

VISIBILITY AND WATTAGE SPECIFICATIONS*

*Bulb Data -

These are special PERKO Navigation Lamps, 120 Volts,

T-10, Prefocus Base, C-8 Filament, Clear 2-3/8 Inch

L.C.L., and must be used to meet the ‘72 COLREGS.

These navigation lights meet the U.S. Coast Guard Requirements

under the ‘72 COLREGS and are classified by Underwriters’

Laboratories Standard U.L. 1104 to meet the ‘72 COLREGS.

NOTE:

WIRE ONLY THROUGH TERMINAL TUBE USING 16/3

SO CABLE WITH 7/16 INCH NOMINAL O.D. TO

RETAIN WATERTIGHT INTEGRITY AND COMPLY

WITH U.L. 1104.

Summary of content (4 pages)

PAGE 1
Bill of Material No. Name of Piece 1 Cap & Cable No. Req. 1 Material Polycarb. Size & Spec. Fig. No. 1105 2 O-Ring Fig. No. 1119 1 Neoprene 4-5/8x4-1/4x1/8 3 Body 1 Brass or Galv. Steel 20 GA-.032 4 Lens 1 Polycarb. 5 Socket Support Stand 1 Brass 6 Socket 1 7 Socket, Mounting Screws 2 S/S 8-32 x 3/4” R.H. 8 Ground Screw & Nut 1 S/S 8-32 x 3/4” R.H. See Note #1 Fig.No. 034-001PLB See Note #2 9 Packing Nut & Gland Ring 1 Polycarb.
PAGE 2
NAVIGATION LIGHT CERTIFICATE OF COMPLIANCE This navigation light has been tested and classified by UNDERWRITERS’ LABORATORIES, INC. (U.L.) in accordance with the ‘72 COLREGS and the U.S. INLAND NAVIGATION RULES ACT OF 1980. When properly installed, and fitted with the correct lamp, this light is approved by the U.S. Coast Guard for use aboard U.S. Coast Guard inspected vessels. This certification is also accepted by other inspecting authorities.
PAGE 3
Bill of Material No. Name of Piece 1 Cap & Cable No. Req. 1 Material Polycarb. Size & Spec. Fig. No. 1105 2 O-Ring Fig. No. 1119 1 Neoprene 4-5/8x4-1/4x1/8 3 Body 1 Brass or Galv. Steel 20 GA-.032 4 Lens 1 Polycarb. See Note #1 5 Socket 1 Phenolic 6 Socket Support Stand 1 Brass 7 Socket, Mounting Screws 2 S/S 8-32 x 3/4” R.H. 8 Ground Screw & Nut 1 S/S 8-32 x 3/4” R.H.
PAGE 4
NAVIGATION LIGHT CERTIFICATE OF COMPLIANCE This navigation light has been tested and classified by UNDERWRITERS’ LABORATORIES, INC. (U.L.) in accordance with the ‘72 COLREGS and the U.S. INLAND NAVIGATION RULES ACT OF 1980. When properly installed, and fitted with the correct lamp, this light is approved by the U.S. Coast Guard for use aboard U.S. Coast Guard inspected vessels. This certification is also accepted by other inspecting authorities.