Owner manual

Figs. 1071/1072 Series

Figs. 1081/1082 Series

FOLD OVER EDGE OF DOOR

1-5/8”

Drill 2-3/8 Inch hole

at No. 1071/1072 #1 Series Lock with Flush Cam Bar and Flexible Plastic Strike Plate.

Cat No. 1071/1072 #2 Series Lock with Offset Adjustable Cam Bar.

Cat No. 1071/1072 #3 Series Lock with Straight Cam Bar and Flexible Plastic Strike Plate.

Cat No. 1081/1082 #1 Series Latch with Flush Cam Bar and Flexible Plastic Strike Plate.

Cat No. 1081/1082 #2 Series Latch with Offset Adjustable Cam Bar.

Cat No. 1081/1082 #3 Series Latch with Straight Cam Bar and Flexible Plastic Strike Plate.

Note: Figs. 1071/1072 Series for use on carpeted surfaces only.

Figs. 1081/1082 Series for use on smooth or carpeted surfaces.

MOUNTING INSTRUCTIONS

These locks or latches are designed to be mounted through surfaces from 1/8 inch to 7/8 inch thick. The

cam bars are adjustable to a maximum of 3 inches from the mounting surface. (The optional strike plate is

supplied only with style #1 & #3).

1). Cut out the template below. Fold on dotted line. Place on mounting surface at desired location with

folded tab overlapping edge.

2). Mark center of hole for drilling.

3). Drill a 2-3/8 inch hole through the mounting surface.

4). Reverse spacer if necessary on very thin surfaces. Use mounting gasket for smooth surfaces

(supplied with Fig. 1081/1082 series only) or discard for carpeted surfaces.

5). Insert lock or latch through the hole in the surface and attach spacer and back-up nut.

6). Mount strike plate (if desired) on suitable surface.

7). Re-assemble cam bar with proper adjustment. Tighten set screw and locking nut with lock washer.

Note: For continued ease of operation, periodically apply a lock cylinder lubricant.

MOUNTING TEMPLATE

PERKO, Inc.

16490 N.W. 13th Avenue

Miami, FL 33169-5707

www.perko.com

(SEE OVER)

6/02

1071INS1

PAGE 1
Cat Cat Cat Cat Cat Cat No. 1071/1072 No. 1071/1072 No. 1071/1072 No. 1081/1082 No. 1081/1082 No. 1081/1082 #1 #2 #3 #1 #2 #3 Series Series Series Series Series Series Lock with Flush Cam Bar and Flexible Plastic Strike Plate. Lock with Offset Adjustable Cam Bar. Lock with Straight Cam Bar and Flexible Plastic Strike Plate. Latch with Flush Cam Bar and Flexible Plastic Strike Plate. Latch with Offset Adjustable Cam Bar. Latch with Straight Cam Bar and Flexible Plastic Strike Plate. Note: Figs.
PAGE 2
Exploded Assembly Drawing for Installation of Fig. Nos. 1071, 1072, 1081 and 1082 Series Flush Locks & Latches Straight Cam Bar Back Up Nut Spacer Mounting Gasket (Supplied on Figs. 1081 & 1082 series only) For installation on smooth surfaces DO NOT USE ON CARPETED SURFACES Set Screws Flush Cam Bar Offset Adjustable Cam Bar Flexible Plastic Strike Used only with Flush or Straight Cam Bars, if desired. Fig. 1071/1072 Series Lock Sets Fig.