User Manual

Swivel Tank Vent Valves for EPA Compliant Fuel Systems
Perko Series 0588S0A for Aluminum Tanks
INSTALLATION INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING
These valves are for use on fuel tanks to comply with the CARB and EPA standards and
meet the requirements of U.S.C.G. Safety Standards (July 31, 2011) for 40 CFR Parts 9,
60, 80 et al. (Control of Diurnal Emissions From Nonroad Spark-Ignition Engines and
Equipment). Note: Inspect valve fitting and snap ring annually for corrosion, replace if
necessary.
Series 0588S0A Tank Vent Valves (TVV)
1. This valve is designed to mount on an aluminum surface.
2. Select your mounting location. Drill 1-3/4” diameter hole for valve receiver.
3. Weld the receiver to the tank
4. Slide the valve into receiver and orient hose barb in the direction of the vent line. Attach
locking snap ring to hold valve in the receiver.
5. Attach 5/16” vent hose onto hose barb and tighten using hose clamps in accordance
with ABYC Fuel System Vent Hose Clamping Standards (H24 Table 3).
PERKO, INC.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
11/12
0588INS3
*The above referenced standards can be obtained from:
(1). American Boat & Yacht Council, Inc. (2) U.S. Coast Guard (3). E.P.A.
613 Third Street, Suite 10 Washington, D.C. 20593 401 “M” Street S.W.
Annapolis, MD 21403 (or your local C.G. office) Washington, D.C. 20460
CARB
&
0588S0A
Valve
Snap Ring
Receiver
Swivel Tank Vent Valves for EPA Compliant Fuel Systems
Perko Series 0588S0A for Aluminum Tanks
INSTALLATION INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING
These valves are for use on fuel tanks to comply with the CARB and EPA standards and
meet the requirements of U.S.C.G. Safety Standards (July 31, 2011) for 40 CFR Parts 9,
60, 80 et al. (Control of Diurnal Emissions From Nonroad Spark-Ignition Engines and
Equipment). Note: Inspect valve fitting and snap ring annually for corrosion, replace if
necessary.
Series 0588S0A Tank Vent Valves (TVV)
1. This valve is designed to mount on an aluminum surface.
2. Select your mounting location. Drill 1-3/4” diameter hole for valve receiver.
3. Weld the receiver to the tank
4. Slide the valve into receiver and orient hose barb in the direction of the vent line. Attach
locking snap ring to hold valve in the receiver.
5. Attach 5/16” vent hose onto hose barb and tighten using hose clamps in accordance
with ABYC Fuel System Vent Hose Clamping Standards (H24 Table 3).
PERKO, INC.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
11/12
0588INS3
*The above referenced standards can be obtained from:
(1). American Boat & Yacht Council, Inc. (2) U.S. Coast Guard (3). E.P.A.
613 Third Street, Suite 10 Washington, D.C. 20593 401 “M” Street S.W.
Annapolis, MD 21403 (or your local C.G. office) Washington, D.C. 20460
CARB
&
0588S0A
Valve
Snap Ring
Receiver