Manual
Cat. No. 0372 Series L.E.D. Spreader Light
The above lights are not designed for navigational use and
are not for use below the waterline.
MOUNTING INFORMATION
Read all instructions before proceeding.
1). These lights are supplied with the proper circuit for operation on a nominal 12 volt
system.
2). These lights contain no user serviceable components.
3). Wiring should be done by a qualified marine electrician. Attach supply
connections to the light, making sure to wire in accordance with both A.B.Y.C.
Standard E-9* and U.S. Coast Guard Safety Standards for Boat Electrical
Systems (33CFR 183)* Observe polarity.
4). The light may be mounted in any orientation that allows for maximum
adjustability, on either a flat or round surface. When mounting on a round surface
install the saddle between the bracket and mounting surface (see Diagram #1).
5). Attach the mounting bracket to the mounting surface using 1/4” Pan Head
mounting screw (see Diagram #1).
* The above referenced standards can be obtained from:
(1). American Boat & Yacht Council, Inc. (2). U.S. Coast Guard
613 Third Street, Suite 10 Washington, D.C. 20593
Annapollis, MD 21403 (or your local C.G. office)
Perko, Inc.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
02/09
0372INS1
DIAGRAM 1
Use 1/4” Pan
Head Screw
Saddle
Cat. No. 0372 Series L.E.D. Spreader Light
The above lights are not designed for navigational use and
are not for use below the waterline.
MOUNTING INFORMATION
Read all instructions before proceeding.
1). These lights are supplied with the proper circuit for operation on a nominal 12 volt
system.
2). These lights contain no user serviceable components.
3). Wiring should be done by a qualified marine electrician. Attach supply
connections to the light, making sure to wire in accordance with both A.B.Y.C.
Standard E-9* and U.S. Coast Guard Safety Standards for Boat Electrical
Systems (33CFR 183)* Observe polarity.
4). The light may be mounted in any orientation that allows for maximum
adjustability, on either a flat or round surface. When mounting on a round surface
install the saddle between the bracket and mounting surface (see Diagram #1).
5). Attach the mounting bracket to the mounting surface using 1/4” Pan Head
mounting screw (see Diagram #1).
* The above referenced standards can be obtained from:
(1). American Boat & Yacht Council, Inc. (2). U.S. Coast Guard
613 Third Street, Suite 10 Washington, D.C. 20593
Annapollis, MD 21403 (or your local C.G. office)
Perko, Inc.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
02/09
0372INS1
DIAGRAM 1
Use 1/4” Pan
Head Screw
Saddle