User Manual

All information in the document is substantially correct at the time
of printing but may be subsequently altered by the company.
Distributed by
1100 Series
1104A-44TG1
@Perkins
®
Recommended SAE viscosity
A single or multigrade oil must be used which conforms to APi-CG4
/ CH4, see illustration below:
Mountings
Maximum static bending moment
at rear face of block ... ... ... ... ... ... ... ... ... ... ... 791 Nm (583 lb/ft)
Load Acceptance
Engine block temperature .. ... ... ... ... ... ... ... ... ... ... ... ... .. 15 °C
Alternator ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... ... . 89%
Maximum ambient temperature . ... ... ... ... ... ... ... ... ... ... ... . 15%
Isochronous governing:
- typical alternator inertia ... ... ... ... ... ... ... ... ... ... ... . 0.498 kgm²
All tests were conducted using an engine which was installed and
serviced to Perkins Engines Company Limited recommendations.
The information given in this document is for guidance only.
Intital load appliaction when engine reaches rated speed
(15 seconds max after engine starts to crank)
Units
1500 rev/
min
1800 rev/
min
Prime Power %
100 100
Load
kWm
(kWe)
59,6
(51.8)
70,3
(60.5)
Transient frequency daviation %
<-10% <-10%
Frequency recovert seconds
< 1 < 1
W1355
0W
5W20
10W30
15W40
20W50
20
-30 -20 -10
0 10 20 30 40 50
o
o
C
-22 -4 14 32 50 68 86 104 122 F
30
40
Ambient temperarture
Perkins Engines Company Limited
Peterborough PE1 5NA United Kingdom
Telephone [phone]
Fax [phone]
www.perkins.com
Publication No. TPD1491E, Issue 1, 03 May 2005. Printed in England. ©Perkins Engines Company Limited.
BDC for engine manuals and specs
https://barringtondieselclub.co.za/