User Manual

54 SENR9977

Testing and Adjusting Section

Flywheel Runou

g00987752

Illustration 61

1. Install the dial indicator. Refer to Illustration 61.

2. Set the pointer of the dial indicator to 0 mm

(0 inch).

3. Turn the flywheel. Read the dial indicator for every

90 degrees.

4. Calculate the difference between the lowest

measurement and the highest measurement of

the four locations. This difference must not be

greater than 0.30 mm (0.012 inch).

i02270535

Flywhee l Hou s in g - Inspect

Concentricity of the Flywheel

Housing

Table 6

Required Tools

Part

Number

Part Description Qty

21825617

Dial gauge 1

Note: This check must be made with the flywheel

and the starter removed and the bolts for the flywheel

housing tightened lightly.

g00913387

Illustration 62

1. Install the 21825617 dial gauge. See Illustration

62.

2. Set the pointer of the 21825617 dial gauge to

0mm(0inch).

3. Check the concentricity at intervals of 90 degrees

around the flywheel housing.

4. Calculate the difference between the lowest

measurement and the highest measurement. This

difference must not be greater than the limit that

isgiveninTable7.

Note: Any necessary adjustment must be made on

the flywheel housing. Then, recheck the concentricity.

Alignment of the Flywheel Housing

Note: This check must be made with the flywheel

and the starter removed and the bolts for the flywheel

housing tightened to the correct torque.