Installation Manual

Chapter 5 N38143

Page 36

Belt drives - 700GM only.

Standard options are:-

An A section pulley with three grooves (B1) at 195mm (7.7ins) diameter.

An A section pulley with one groove (B2) at 143mm (5.6ins) diameter.

In this case the maximum power which can be taken will be limited by the belts, and it will be necessary to

calculate for marginal applications.

Caution: Additional inertia must not be added to the P.T.O. without specialist advice. Consult your distributor

if you need advice about non-standard drive arrangements.

•