Installation Manual

Chapter 2 N38143

Page 10

The weight of the exhaust system should be supported by brackets and not carried by the bellows, as shown

in (G).

Bracket with link to allow movement due to expansion in the exhaust system (horizontal exhaust systems

should be suspended from the deck head using similar brackets.

Note: Rigid brackets should not be used

Insulating lagging

Rigid bracket to support the weight of the vertical exhaust system

Heat blanket

Twin stainless steel bellows tted to avoid torsional load on bellows unit - it is strongly recommended that twin

bellows are used.

Turbocharger adaptor (except 415GM, 422GM, 700GM, 4GM, & 4.4GM)

elbow