Operation and maintenance manual

6. Fasten the assembly to the fuel filter base with

setscrew (2).

The fuel system will need to be primed after the new

filter is installed. Refer to this Operation and

Maintenance Manual, “Fuel System - Prime”.

Fuel Filter with Element

1. Close the fuel supply valve (1).

Illustration 50 g01334893

Typical example

2. Clean the outside of the fuel filter assembly.

3. Loosen the locking ring (2).

4. Remove the casing (3) for the filter and the

element. Ensure that any fluid is drained into a

suitable container.

Illustration 51 g01334895

Typical example

Note: Do not fill the fuel filter with fuel. The fuel will

not be filtered and the fuel could be contaminated.

Contaminated fuel can damage your fuel system.

5. Assemble the following items: seal (5), filter

element (6) and casing (3).

6. Install the assembled items to the filter base (4).

7. Install the locking ring (2) to the filter head. Rotate

the locking ring in order to lock the assembly.

The fuel system will need to be primed after the new

filter is installed. Refer to Operation and Maintenance

Manual, “Fuel System - Prime”.

SEBU9064

Maintenance Recommendations

Fuel System Secondary Filter - Replace