Installation Manual

N40475 Chapter 10
Page 63
Provision for power take-off
Warning! Remove all paint traces from the mating
faces before assembly.
Fit the power take-off shaft, (gure 1 item 1) using
bolts (gure 1 item 2) and tighten to a nal torque of
84 lb.ft. (115Nm)
Fit the key (gure 1 item 3) to the power take-off shaft
.
For axial drives
For axial drives it is recommended that a exible drive
coupling between the engine and any given load is
used.
For belt drives
Standard options are:-
Either a 5” ‘A’ section pulley with three grooves (gure
2 item 1) and a taper lock (gure 2 item 2).
or
A 5” ‘B’ section pulley with two grooves (gure 3).
In this case the maximum power which can be taken
will be limited by the belts, and it will be necessary to
calculate for marginal applications.
Caution: Additional inertia must not be added to the
P.T.O. shaft without specialist advice. Consult your
distributor if you need advice about non-standard
drive arrangements.
Figure 1
Figure 2
Figure 3