Installation Manual

N40475 Chapter 8
Page 41
Port or starboard expansion connectors
The MJB provides two connectors, one for port
and one for starboard, which will be used for future
expansion. The pin out is the same for both the port
and starboard connectors.
Starter Interlock (Pins 1 & 2)
The starter interlock provides a means of preventing
the engine from starting through a switched circuit.
The starter interlock may be wired through a neutral
safety switch or other similar device. If no such device
is installed, a jumper wire should be installed between
expansion connector pins 1 and 2 as in gure 25.
Figure 26 shows a neutral safety switch (1), between
the starter interlock pins 1 and 2.
Figure 24
Figure 25
Figure 26