Installation Manual

N40475 Chapter 8
Page 33
Change screen
Pressing the alarm button will cause the System
Information screen to be displayed.
Change troll mode
Pressing the alarm button will cause the displayed
Troll Mode to scroll through the available troll modes
(Traditional and Intelli-Troll).
Change troll speed
Selecting Change Troll Set Speed (as gure 13) will
display the following screen. Pressing + will increase
the set speed by 1 rpm and pressing – will decrease
the set speed by 1 rpm. Pressing Save will cause
the MMPD to send the data to the PCP (and exit the
screen), and pressing Cancel will cause the MMPD to
exit the screen without sending any data to the PCP.
Change engine sync master
Pressing the alarm button will cause the displayed
Engine Sync Master to scroll through the available
sync master selections (PORT and STBD).
Active station location
Displays the Active Station Location (Bridge, Port
Wing, Starboard Wing, Tower, Engine Room, Aft
Station, Fly Bridge, and Bow Station). If the PCP
reports that there is no active station, then the MMPD
will display NONE in the Active Station Location eld.
Button status indicator
The Station Button Status indicators display the
button status as read by the active control station.
• SA – Activate Station Button Status
• SVM – Slow Vessel Mode Button Status
• SYC – Engine Synchronization Button Status
• N – Idle (Neutral) Lockout Button Status
• TR – Trolling Mode Button Status
Lamp status indicator
The Station Lamp Status indicators display the
commanded lamp status from the active control
station.
• SA – Activate Station Lamp Status
• SVM – Slow Vessel Mode Lamp Status
• SYC – Engine Synchronization Lamp Status
• N – Idle (Neutral) Lockout Lamp Status
• TR – Trolling Mode Lamp Status
Figure 13