Installation Manual

Chapter 8 N40475
Page 32
Change screen
Pressing the alarm button will cause the Control
System Information screen to be displayed. This
option is only available if the MMPD has detected a
Powertrain Control Processor (PCP) on the CAN data
link.
Change user
Pressing the alarm button will cause the displayed
User Name text to scroll through the available user
names.
Change unit location
Pressing the alarm button will cause the displayed
Unit Location text to scroll through the available
location selections.
The vessel locations that are available are: Bridge,
Port Wing, Starboard Wing, Tower, Engine Room, Aft
Station, Fly Bridge, and Bow Station.
Change display units
Pressing the alarm button will cause the displayed
Display Units text to scroll through the available units
selections (English and Metric).
Change vessel speed units
Pressing the alarm button will cause the displayed
Vessel Speed Units text to scroll through the available
units selections (Knots, MPH, and KPH).
Change system information screen
The Control System Information screen will only be
displayed if a Powertrain Control Processor (PCP)
is detected on the data link. This screen will display
the PCP software part number, Troll Mode, Troll Set,
Engine Speed, Engine Sync Master, Active Station
Location, active Station Button Status, and Active
Station Lamp Status. Pressing the button labelled
Menu will display the screen shown in gure 12.
On this screen the button functions are re-dened
as shown on the right side of the screen. However,
in the presence of a diagnostic code window button
actions return to their normal denitions. Pressing
the up or down arrows will cause the top menu item
(labelled Change Screen) to scroll through the items
to be modied (Change Screen, Change Troll Mode,
Change Set Speed, Change Sync Master, and Change
Station Location) and cause the selected data to be
displayed in reverse video. Pressing the alarm button
will cause the specied parameter to scroll through
each available value. Pressing the button labelled
Exit will return the display to the Control System
Information screen and transmit any changed data
items to the PCP.
Figure 12