User Manual
N40469 Chapter 5
Page 39
How to renew the canister of the
lubricating oil lter
Warning! Discard the used canister and lubricating
oil in a safe place and in accordance with local
regulations.
1. Put a tray or plastic bag under or around the lter
to retain spilt lubricating oil.
2. Remove the lter canister (gure 21 item 1) with
a strap wrench or similar tool. Ensure that the
adaptor (gure 22 item 1) is secure in the lter
head. Then discard the canister.
3. Clean the lter head.
4. Lubricate the top of the new canister seal (gure
22 item 2) with clean engine lubricating oil.
Caution: Do not prell with oil.
1. Fit the new canister until the surfaces make
contact, then tighten it by hand an extra 3/4’s of a
turn only. Do not use a strap wrench.
2. Ensure that there is lubricating oil in the sump.
Operate the starter motor until the oil pressure
warning light is extinguished or there is a reading
on the gauge.
3. Operate the engine and check for leakage from
the lter. When the engine has cooled, check the
oil level on the dipstick and put more oil into the
sump, if necessary.
Caution: The canister contains a valve and special
tube to ensure that lubricating oil does not drain from
the lter. Therefore, ensure that the correct canister
is used.
Figure 21
Figure 22