Troubleshooting

(Table 4, contd)
J1939 Code
Description
Refer to Procedure
110-3
Engine Coolant Temperature : Voltage Above Normal Sensor Signal (Analog, Passive) - Test
110-4
Engine Coolant Temperature : Voltage Below Normal Sensor Signal (Analog, Passive) - Test
110-15
Engine Coolant Temperature : High - least severe (1) Coolant Temperature Is High
110-16
Engine Coolant Temperature : High - moderate severity (2) Coolant Temperature Is High
152-2
Number Of ECU Resets : Erratic, Intermittent, or Incorrect
ECM Memory - Test
157-0
Engine Injector Metering Rail #1 Pressure : High - most severe
(3)
Fuel Rail Pressure Problem
157-2
Engine Injector Metering Rail #1 Pressure : Erratic, Intermit-
tent, or Incorrect
Fuel Rail Pressure Problem
157-3
Engine Injector Metering Rail #1 Pressure : Voltage Above
Normal
Sensor Signal (Analog, Active) - Test
157-4
Engine Injector Metering Rail #1 Pressure : Voltage Below
Normal
Sensor Signal (Analog, Active) - Test
157-10
Engine Injector Metering Rail #1 Pressure : Abnormal Update
Rate
Sensor Signal (Analog, Active) - Test
157-16
Engine Injector Metering Rail #1 Pressure : High - moderate
severity (2)
Fuel Rail Pressure Problem
157-17
Engine Injector Metering Rail #1 Pressure : Low - least severe
(1)
Fuel Rail Pressure Problem
157-18
Engine Injector Metering Rail #1 Pressure : Low - moderate se-
verity (2)
Fuel Rail Pressure Problem
166-2
Engine Rated Power : Erratic, Intermittent, or Incorrect ECM Memory - Test
166-14
Engine Rated Power : Special Instuction ECM Memory - Test
168-3
Battery Potential / Power Input 1 : Voltage Above Normal Electrical Power Supply - Test
168-4
Battery Potential / Power Input 1 : Voltage Above Normal Electrical Power Supply - Test
172-3
Engine Air Inlet Temperature : Voltage Above Normal Sensor Signal (Analog, Passive) - Test
172-4
Engine Air Inlet Temperature : Voltage Below Normal Sensor Signal (Analog, Passive) - Test
173-3
Engine Exhaust Gas Temperature : Voltage Above Normal Sensor Signal (Analog, Passive) - Test
173-4
Engine Exhaust Gas Temperature : Voltage Below Normal Sensor Signal (Analog, Passive) - Test
174-3
Engine Fuel Temperature 1 : Voltage Above Normal Sensor Signal (Analog, Passive) - Test
174-4
Engine Fuel Temperature 1 : Voltage Below Normal Sensor Signal (Analog, Passive) - Test
190-8
Engine Speed : Abnormal Frequency, Pulse Width, or Period Speed/Timing - Test
190-15
Engine Speed : High - least severe (1) Engine Overspeeds
558-2
Accelerator Pedal 1 Low Idle Switch : Erratic, Intermittent, or
Incorrect
Idle Validation - Test
593-31
Engine Idle Shutdown has Shutdown Engine
This code indicates that an engine idle shutdown is about
to occur. This code does not represent a fault.
If equipped, the warning lamp will come on.
(continued)
UENR0612-07 23
Diagnostic Trouble Codes
This document has been printed from SPI2. NOT FOR RESALE