Troubleshooting

Note: Position (4) is not available on the mode
selection switch. If the signal voltage range is
between 3.7 and 4.4 VDC, the mode that is selected
will be the same as position (3).
Illustration 36 g03728025
Typical example of the schematic for the mode selection switch
Not all connectors are shown. Refer to the Electrical Schematic for the application.
Illustration 37 g02723018
Typical view of the pin locations on the P1 connector
for the mode selection switch
(55) Mode selection switch signal
(77) Mode selection switch ground
160 UENR0612-07
Circuit Tests
This document has been printed from SPI2. NOT FOR RESALE