Troubleshooting

i06229778
Injector Solenoid - Test
This procedure covers the following codes:
Table 77
Diagnostic Trouble Codes for the Circuit for the Injector Solenoids
J1939
Code
Description
Notes
651-5 Engine Injector Cylinder #01 : Current
Below Normal
These diagnostic codes are designed to indicate an open circuit (low current) in either the
solenoid or the wiring for the electronic unit injector in the applicable cylinder.
The Electronic Control Module (ECM) detects the following conditions:
A low current condition (open circuit) for the applicable cylinder for at least three attempts
to actuate the solenoid.
The ECM will log the diagnostic code.
The engine will have low power and/or rough running.
An open circuit will prevent the operation of the electronic unit injector.
652-5 Engine Injector Cylinder #02 : Current
Below Normal
653-5 Engine Injector Cylinder #03 : Current
Below Normal
654-5 Engine Injector Cylinder #04 : Current
Below Normal
651-6 Engine Injector Cylinder #01 : Current
Above Normal
These diagnostic codes are designed to indicate a short circuit (high current) in either the
solenoid or the wiring for the electronic unit injector in the applicable cylinder.
The ECM detects the following conditions:
A high current condition (short circuit) for the applicable cylinder for at least five attempts to
actuate the solenoid.
The ECM will log the diagnostic code.
The engine will have low power and/or rough running.
A short circuit will prevent the operation of the electronic unit injector.
652-6 Engine Injector Cylinder #02 : Current
Above Normal
653-6 Engine Injector Cylinder #03 : Current
Above Normal
654-6 Engine Injector Cylinder #04 : Current
Above Normal
2797-6 Engine Injector Group 1 : Current
Above Normal
The ECM detects the following conditions:
A short circuit condition in the driver for injector 1 and injector 4.
The fault is present for at least five attempts to actuate the driver.
The ECM will log the diagnostic code.
The engine will have low power and/or rough running. The engine may shut down.
A short circuit will prevent the operation of the two electronic unit injectors.
2797-7 Engine Injector Group 1 : Not Re-
sponding Properly
The ECM is unable to actuate any of the injectors.
The engine will be derated.
The engine will shut down or the engine will be unable to start.
2798-6 Engine Injector Group 2 : Current
Above Normal
The ECM detects the following conditions:
A short circuit condition in the driver for injector 2 and injector 3.
The fault is present for at least five attempts to actuate the driver.
The ECM will log the diagnostic code.
The engine will have low power and/or rough running. The engine may shut down.
A short circuit will prevent the operation of the two electronic unit injectors.
UENR0612-07 153
Circuit Tests
This document has been printed from SPI2. NOT FOR RESALE