SPECIFICATIONS

NOTICE

Refer to Systems Operation, Testing and Adjust-

ing, “Cleanliness of Fuel System Components”

for detailed information on the standards of

cleanliness that must be observed during ALL

work on the fuel system.

Illustration 7 g02621238

Typical example

(1) Tighten the fuel pressure relief valve to the

following torque. . . . . . . . . . . . . . .100 N·m ((74 lb ft))

(2) Tighten the bolts to the following torque.

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 N·m ((18 lb ft))

(3) Tighten the bolts to the following torque.

. . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 N·m ((89 lb in))

(4) Tighten the fuel pressure sensor to the following

torque. . . . . . . . . . . . . . . . . . . . . . . . 70 N·m ((52 lb ft))

i04332521

Lifter Group

Illustration 8 g02488296

Typical example

(B) 26 mm (1.02362 inch)

(D) 38 ± 0.25 mm (1.49606 ± 0.00984 inch)

(A) Diameter of the lifter body

. . . . . . 14.780 ± 0.04 mm ((0.58189 ± 0.00157 inch))

. . . . . . . . . 67 ± 0.25 mm ((2.63779 ± 0.00984 inch))

(E) Diameter of the lifter body

. . . . . . 14.970 ± 0.02 mm ((0.58937 ± 0.00079 inch))

(F) Diameter of the lifter body

. . . . . . 14.780 ± 0.04 mm ((0.58189 ± 0.00157 inch))

Bore diameter in the cylinder block

. . . . . . . 15.4 to 15.6 mm ((0.60630 to 0.61417 inch))

Clearance

Clearance of the lifter

. .0.020 to 0.054 mm ((0.00079 to 0.00213 inch))

UENR0622-02

Specifications Section

This document has been printed from SPI2. NOT FOR RESALE