SPECIFICATIONS

NOTICE
Refer to Systems Operation, Testing, and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
If necessary, install a new fuel filter element to
canister (6). Refer to Operation and Maintenance
Manual, “Fuel System Secondary Filter - Replace” for
the correct procedure.
Illustration 5 g02621258
Typical example
(1) Tighten the connections to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 N·m ((18 lb ft))
(2) Tighten the screw to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.5 N·m ((22 lb in))
(3) Tighten the screw to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 N·m ((13 lb ft))
(4) Tighten the setscrews to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 N·m ((18 lb ft))
(5) Tighten the fuel temperature sensor to the
following torque. . . . . . . . . . . . . . . . 22 N·m ((16 lb ft))
i05240680
Fuel Filter Base
(Primary Fuel Filter Base)
NOTICE
Refer to Systems Operation, Testing, and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
If necessary, install a new fuel filter element to
canister (2). Refer to Operation and Maintenance
Manual, “Fuel System Primary Filter (Water
Separator) Element - Replace” for the correct
procedure.
Illustration 6 g02606186
Typical example
(1) Tighten the water in fuel sensor to the following
torque. . . . . . . . . . . . . . . . . . . . . . . 2.5 N·m ((22 lb in))
Note: Tighten water in fuel sensor until the O-ring
seal comes into contact with the bowl of the water
separator. Tighten the water in fuel sensor an
additional 180 degrees.
(3) Tighten the connection to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 N·m ((15 lb ft))
(4) Tighten the setscrews to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 N·m ((32 lb ft))
i04424550
Fuel Manifold (Rail)
Refer to Operation and Maintenance Manual
,
“
General Hazard Information and High Pressure Fuel
Lines” before adjustments and repairs are performed.
6 UENR0622-02
Specifications Section
This document has been printed from SPI2. NOT FOR RESALE