SPECIFICATIONS

(2) (3) Torque for the nuts on the fuel injection lines
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 N·m ((18 lb ft))
i05240671
Fuel Injection Pump
NOTICE
Refer to Systems Operation, Testing, and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
Ensure that all adjustments and repairs are
performed by authorized personnel that have had the
correct training.
Illustration 3 g02621683
Typical example
Tighten the studs (not shown) to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 N·m ((13 lb ft))
(1) Tighten the nuts to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 N·m ((18 lb ft))
i05240672
Fuel Injectors
Refer to Operation and Maintenance Manual,
“General Hazard Information and High Pressure Fuel
Lines” before adjustments and repairs are performed.
NOTICE
Refer to Systems Operation, Testing and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
Illustration 4 g03342579
Typical example
(2) Clamp
(4) Washer
(5) O ring seal
(3) Tighten the studs in the cylinder head to the
following torque. . . . . . . . . . . . . . . . 20 N·m ((15 lb ft))
(1) Tighten the injector fastening nut to an initial
torque. . . . . . . . . . . . . . . . . . . . . . . . 15 N·m ((11 lb ft))
(1) Tighten the injector fastening nut to a final torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 N·m ((18 lb ft))
i05240679
Fuel Filter Base
(Secondary Fuel Filter Base)
UENR0622-02
5
Specifications Section
This document has been printed from SPI2. NOT FOR RESALE