SPECIFICATIONS

Backlash between the idler gear (2) and the

accessory drive gear (if equipped) (3)

. . . . 0.07 to 0.17 mm ((0.00276 to 0.00669 inch))

Backlash between the idler gear (2) and the

camshaft gear (4)

. . . . 0.07 to 0.17 mm ((0.00276 to 0.00669 inch))

Backlash between the camshaft gear (4) and the

crankshaft gear (5)

. . . . 0.07 to 0.17 mm ((0.00276 to 0.00669 inch))

Backlash between the crankshaft gear (5) and

the oil pump idler gear (6)

. . . . 0.07 to 0.17 mm ((0.00276 to 0.00669 inch))

Backlash between the oil pump idler gear (6) and

the oil pump gear (7)

. . . . 0.07 to 0.17 mm ((0.00276 to 0.00669 inch))

i04346169

Flywheel

Illustration 64 g02501156

Typical example

(1) Flywheel ring gear

Heat the flywheel ring gear to the following

temperature. . . . . . . . . . . . . . . . 180° C ((356° F))

Note: Do not use an oxyacetylene torch to heat the

flywheel ring gear.

(2) Flywheel

(3) Bolt

Tighten the flywheel bolts to an initial torque.

. . . . . . . . . . . . . . . . . . . . . . . . . . 30 N·m ((22 lb ft))

Tighten the flywheel bolts to the additional

amount. . . . . . . . . . . . . . . . . . . . . . . . . 90 degrees

42 UENR0622-02

Specifications Section

This document has been printed from SPI2. NOT FOR RESALE