SPECIFICATIONS

Specifications Section
i06719934
Engine Design
Illustration 1 g06090557
Cylinder and valve location
(A) Exhaust valve
(B) Inlet valve
Bore . . . . . . . . . . . . . . . . . . . . . . . 99 mm ((3.90 inch))
Stroke . . . . . . . . . . . . . . . . . . . . . 110 mm ((4.33 inch))
Displacement . . . . . . . . . . . . . . . . . . . . 3.4 L ((207 in
3
))
Cylinder arrangement . . . . . . . . . . . . . . . . . . . . In-line
Type of combustion . . . . . . . . . . . . . . . Direct injection
Compression ratio
Turbocharged aftercooled . . . . . . . . . . . . . 17.5:1
Number of cylinders . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Valves per cylinder . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Firing order . . . . . . . . . . . . . . . . . . . . . . . . . . . 1, 3, 4, 2
When the crankshaft is viewed from the flywheel end
of the engine, the crankshaft rotates in the following
direction: . . . . . . . . . . . . . . . . . . . . . .Counterclockwise
When the camshaft is viewed from the flywheel end
of the engine, the camshaft rotates in the following
direction: . . . . . . . . . . . . . . . . . . . . . .Counterclockwise
Note: The left side and the right side of the engine
are viewed from the flywheel end. The No. 1 cylinder
is the front cylinder.
i05240674
Fuel Injection Lines
Contact with high pressure fuel may cause fluid
penetration and burn hazards. High pressure fuel
spray may cause a fire hazard. Failure to follow
these inspection, maintenance and service in-
structions may cause personal injury or death.
Refer to Operation and Maintenance Manual,
“General Hazard Information and High Pressure Fuel
Lines” before adjustments and repairs are performed.
NOTICE
Refer to Systems Operation, Testing, and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
Ensure that all adjustments and repairs are
performed by authorized personnel that have had the
correct training.
Illustration 2 g02501177
Typical example
(1) Tighten the screws to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 N·m ((89 lb in))
4 UENR0622-02
Specifications Section
This document has been printed from SPI2. NOT FOR RESALE