SPECIFICATIONS

i04335149
Piston Cooling Jet
Illustration 56 g02490436
Typical example
(1) Tighten the bolt to the following torque.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 N·m ((13 lb ft))
Piston Cooling Jet Alignment
Illustration 57 g01352578
(2) Piston cooling jet
(3) Rod
(4) Cylinder block
Use the following procedure in order to check the
alignment of the piston cooling jet.
1. Insert rod (3) into the end of the piston cooling jet
(2). Rod (3) has a diameter of 1.70 mm
(0.067 inch). Rod (3) must protrude out of the top
of the cylinder block.
2. Dimension (A) is 50.75 mm (1.9980 inch) and
dimension (B) is 9.35 mm (0.3681 inch).
Dimension (A) and dimension (B) are tangential to
the cylinder bore (4).
3. The position of the rod (3) must be within
dimension (C). Dimension (C) is 14 mm
(0.5512 inch).
Note: Ensure that the rod (3) cannot damage the
piston cooling jet when the alignment is checked. The
piston cooling jets cannot be adjusted. If a piston
cooling jet is not in alignment, the piston cooling jet
must be replaced.
38 UENR0622-02
Specifications Section
This document has been printed from SPI2. NOT FOR RESALE