SPECIFICATIONS

Illustration 53 g02859357
Typical example
(3) Diameter of the finished bore for the piston pin
. . . . . 36.01 to 36.02 mm ((1.41771 to 1.41811 inch))
(4) Distance between the parent bores
. . . . . . 219.05 to 219.1 mm ((8.6240 to 8.6260 inch))
(5) Diameter for the finished bore for the connecting
rod bearing
. . .67.833 to 67.848 mm ((2.67059 to 2.67118 inch))
Refer to table 6 for the length of connecting rod.
Table 6
Specifications for the Connecting Rod
Length Of The Connecting Rod
161.8 to 162.2 mm (6.37 to 6.38 inch)
i04332709
Piston and Rings
Illustration 54 g01155119
Typical example
(1) Top compression ring
Width of top compression ring
. .2.068 to 2.097 mm ((0.08142 to 0.08256 inch))
Ring gap
. . 0.112 to 0.157 mm ((0.00441 to 0.00618 inch))
Note: When you install a new top compression ring,
make sure that the word “TOP” is facing the top of the
piston. New top piston rings have a black
identification mark. The identification mark must be
on the left of the ring end gap when the top piston
ring is installed on an upright piston.
(2) Intermediate compression ring
Width of intermediate compression ring
. .1.970 to 1.990 mm ((0.07756 to 0.07835 inch))
The clearance between a new intermediate
compression ring and the piston groove in a new
piston
. . . . 0.06 to 0.16 mm ((0.00236 to 0.00630 inch))
Ring gap
. .0.060 to 0.100 mm ((0.00236 to 0.00394 inch))
Note: When you install a new intermediate
compression ring, make sure that the word “TOP” is
facing the top of the piston. New intermediate rings
have a blue identification mark. The identification
mark must be on the left of the ring end gap when the
top piston ring is installed on an upright piston.
(3) The oil control ring
36 UENR0622-02
Specifications Section
This document has been printed from SPI2. NOT FOR RESALE