SPECIFICATIONS

i04479212

Connecting Rod

Illustration 51 g02859356

Typical example

(1) The bearing shell for the connecting rod

For the correct procedure to install the bearing shell

for the connecting rod, refer to Disassembly and

Assembly, “Pistons and Connecting Rods -

Assemble”.

Table 5

Thickness of Connecting Rod

Bearing at the Center

1.955 to 1.968 mm

(0.07697 to 0.07748 inch)

Thickness of Bearing Cap at

the Center

1.955 to 1.968 mm

(0.07697 to 0.07748 inch)

Bearing Clearance

0.080 to 0.035 mm

(0.00315 to 0.00138 inch)

Illustration 52 g02844317

Typical example

(A) Class of weight

(B) Part number

(D) Date of production (Year)

(E) Serial number markings on the connecting rod and connecting

rod cap

The mating surfaces of the connecting rod are

produced by hydraulically fracturing the forged

connecting rod. Ensure that the correct cap for the

connecting rod is installed with the correct connecting

rod. Ensure that the serial numbers (E) for both

components match. Refer to illustration 52 for more

information.

(2) Torque of the setscrews for the connecting rod

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 N·m ((37 lb ft))

Tighten the setscrews (2) for the connecting rod for

an additional 70 degrees. The setscrews for the

connecting rod must be replaced after this procedure.

UENR0622-02 35

Specifications Section

This document has been printed from SPI2. NOT FOR RESALE