Operation and maintenance manual

Clean the cooling system whenever the coolant is
contaminated or whenever the coolant is foaming.
i06707156
Fluid Recommendations
(Fuel Specification)
Glossary
ISO International Standards Organization
ASTM American Society for Testing and
Materials
HFRR High Frequency Reciprocating Rig
for Lubricity testing of diesel fuels
FAME Fatty Acid Methyl Esters
CFR Co-ordinating Fuel Research
ULSD Ultra Low Sulfur Diesel
RME Rape Methyl Ester
SME Soy Methyl Ester
EPA Environmental Protection Agency of
the United States
PPM Parts Per Million
DPF Diesel Particulate Filter
v/v (volume of solute)/(volume of solution)
CFPP Cold Filter Plugging Point
BTL Biomass to liquid
GTL Gas to liquid
CTL Coal to liquid
HVO Hydrotreated Vegetable Oil
General Information
NOTICE
Every attempt is made to provide accurate, up-to-
date information. By use of this document you agree
that Perkins Engines Company Limited is not respon-
sible for errors or omissions.
NOTICE
These recommendations are subject to change with-
out notice. Contact your local Perkins distributor for
the most up-to-date recommendations.
Diesel Fuel Requirements
Perkins is not in a position to continuously evaluate
and monitor all worldwide distillate diesel fuel
specifications that are published by governments and
technological societies.
The "Perkins Specification for Distillate Diesel Fuel"
provides a known reliable baseline to judge the
expected performance of distillate diesel fuels that
are derived from conventional sources.
Satisfactory engine performance depends on the use
of a good quality fuel. The use of a good quality fuel
will give the following results: long engine life and
acceptable exhaust emissions levels. The fuel must
meet the minimum requirements that are stated in
the table 16 .
NOTICE
The footnotes are key part of the Perkins "Specifica-
tion for Distillate Diesel Fuel" Table. Read ALL of the
footnotes.
74
SEBU8726-03
Maintenance Section
Fluid Recommendations
This document has been printed from SPI2. NOT FOR RESALE