Operation and maintenance manual

Recommendation for Crankcase
Breather Protection
Crankcase ventilation gases can contain a large
quantity of water vapor. This water vapor can freeze
in cold ambient conditions and can plug or damage
the crankcase ventilation system.
The breather heater or other breather thermal
protection is important and any OEM equipment must
be operational to prevent the risk of breather freezing
for operation below −5° C (23° F).
i05849931
Fuel and the Effect from Cold
Weather
Note: Only use grades of fuel that are recommended
by Perkins. Refer to this Operation and Maintenance
Manual, “Fluid Recommendations”.
Properties of the diesel fuel can have a significant
effect on the engine cold start capability. It is critical
that the low temperature properties of diesel fuel are
acceptable for the minimum ambient temperature the
engine is expected to see in the operation.
Following properties are used to define fuels low
temperature capability:
• Cloud point
• Pour point
• Cold Filter Plugging Point (CFPP)
The cloud point of the fuel is the temperature at
which waxes naturally found in the diesel fuel begin
to form crystals. The cloud point of the fuel must be
below lowest ambient temperature to prevent filters
from plugging.
Cold Filter Plugging Point is a temperature at which a
particular fuel will pass through a standardized
filtration device. This CFPP gives an estimate of the
lower operability temperature of fuel
Pour point is the last temperature before the fuel flow
stops and waxing of the fuel will start.
Be aware of these properties when diesel fuel is
purchased. Consider the average ambient air
temperature for the engines application. Engines that
are fueled in one climate may not operate well if the
engines are shipped to colder climate. Problems can
result due to changes in temperature.
Before troubleshooting for low power or for poor
performance in the winter, check the fuel for waxing
The following components can provide a means of
minimizing fuel waxing problems in cold weather:
• Fuel heaters, which may be an OEM option
• Fuel line insulation, which may be an OEM option
Winter and arctic grades of diesel fuel are available in
the countries and territories with severe winters. For
more information refer to the Operation and
Maintenance Manual, “Fuel For Cold Weather
Operation”
Another important fuel property which can affect cold
start and operation of diesel engine is Cetane
number. Detail and requirements of this property are
given in this Operation and Maintenance Manual,
“Fluid Recommendations”.
i02323237
Fuel Related Components in
Cold Weather
Fuel Tanks
Condensation can form in partially filled fuel tanks.
Top off the fuel tanks after you operate the engine.
Fuel tanks should contain some provision for draining
water and sediment from the bottom of the tanks.
Some fuel tanks use supply pipes that allow water
and sediment to settle below the end of the fuel
supply pipe.
Some fuel tanks use supply lines that take fuel
directly from the bottom of the tank. If the engine is
equipped with this system, regular maintenance of
the fuel system filter is important.
Drain the water and sediment from any fuel storage
tank at the following intervals: weekly, service
intervals and refueling of the fuel tank. This will help
prevent water and/or sediment from being pumped
from the fuel storage tank and into the engine fuel
tank.
Fuel Filters
A primary fuel filter is installed between the fuel tank
and the engine fuel inlet. After you change the fuel
filter, always prime the fuel system in order to remove
air bubbles from the fuel system. Refer to the
Operation and Maintenance Manual in the
Maintenance Section for more information on priming
the fuel system.
SEBU8726-03
63
Operation Section
Fuel and the Effect from Cold Weather
This document has been printed from SPI2. NOT FOR RESALE