Operation and maintenance manual

Operation Section
Lifting and Storage
i06704010
Product Lifting
Illustration 27 g02475658
Typical example
NOTICE
Never bend the eyebolts and the brackets. Only load
the eyebolts and the brackets under tension. Re-
member that the capacity of an eyebolt is less as the
angle between the supporting members and the ob-
ject becomes less than 90 degrees.
When it is necessary to remove a component at an
angle, only use a link bracket that is properly rated for
the weight.
Use a hoist to remove heavy components. Use an
adjustable lifting beam to lift the engine. All
supporting members (chains and cables) should be
parallel to each other. The chains and cables should
be perpendicular to the top of the object that is being
lifted.
Some removals require lifting the fixtures to obtain
correct balance and safety.
To remove the engine, use the lifting eyes that are on
the engine. Radiators that are approved by Perkins
can be lifted with the engine.
Lifting eyes are designed and installed for specific
engine arrangements. Alterations to the lifting eyes
and/or the engine make the lifting eyes and the lifting
fixtures obsolete. If alterations are made, ensure that
correct lifting devices are provided. Consult your
Perkins dealer or your Perkins distributor for
information regarding fixtures for correct engine
lifting.
Note: The engine is equipped with three lifting eyes.
All the lifting eyes must be used to lift the engine.
i04084189
Product Storage
(Engine and Aftertreatment)
Perkins are not responsible for damage which may
occur when an engine is in storage after a period in
service.
Your Perkins dealer or your Perkins distributor can
assist in preparing the engine for extended storage
periods.
Condition for Storage
The engine must be stored in a water proof building.
The building must be kept at a constant temperature.
Engines that are filled with Perkins ELC will have
coolant protection to an ambient temperature of
−36° C (−32.8° F). The engine must not be subjected
to extreme variations in temperature and humidity.
Storage Period
An engine can be stored for up to 6 months provided
all the recommendation are adhered to.
Storage Procedure
Keep a record of the procedure that has been
completed on the engine.
Note: Do not store an engine that has biodiesel in the
fuel system.
1. Ensure that the engine is clean and dry.
a. If the engine has been operated using biodiesel,
the system must be drained and new filters
installed. The fuel tank will require flushing.
32
SEBU8726-03
Operation Section
Lifting and Storage
This document has been printed from SPI2. NOT FOR RESALE