Operation and maintenance manual

The ECM provides an electronic governor that
controls the injector output to maintain the desired
engine rpm.
Engine Cooling and Lubrication
The cooling system and lubrication system consists
of the following components:
• Belt driven centrifugal water pump
• Water temperature regulator which regulates the
engine coolant temperature
• Gear-driven rotor type oil pump
• Multi-plate oil cooler
The engine lubricating oil is cooled and the engine
lubricating oil is filtered.
Engine Service Life
Engine efficiency and maximum utilization of engine
performance depend on the adherence to proper
operation and maintenance recommendations. In
addition, use recommended fuels, coolants, and
lubricants. Use the Operation and Maintenance
Manual as a guide for required engine maintenance.
Aftermarket Products and Perkins
Engines
Perkins does not warrant the quality or performance
of non-Perkins fluids and filters.
When auxiliary devices, accessories, or
consumables (filters, additives, catalysts,) which are
made by other manufacturers are used on Perkins
products, the Perkins warranty is not affected simply
because of such use.
However, failures that result from the installation
or use of other manufacturers devices,
accessories, or consumables are NOT Perkins
defects. Therefore, the defects are NOT covered
under the Perkins warranty.
Aftertreatment System
The aftertreatment system is approved for use by
Perkins. To be emission-compliant only, the approved
Perkins aftertreatment system must be used on a
Perkins engine.
26
SEBU8726-03
Product Information Section
Product Description
This document has been printed from SPI2. NOT FOR RESALE