Operation and maintenance manual

Make sure that all clamps, guards, and heat shields
are installed correctly. During engine operation, this
check will help to prevent vibration, rubbing against
other parts, and excessive heat.
Regeneration
The exhaust gas temperature during regeneration
will be elevated. Follow proper fire prevention
instructions and use the disable switch function when
appropriate.
i02143194
Crushing Prevention and
Cutting Prevention
Support the component correctly when work beneath
the component is performed.
Unless other maintenance instructions are provided,
never attempt adjustments while the engine is
running.
Stay clear of all rotating parts and of all moving parts.
Leave the guards in place until maintenance is
performed. After the maintenance is performed,
reinstall the guards.
Keep objects away from moving fan blades. The fan
blades will throw objects or cut objects.
When objects are struck, wear protective glasses in
order to avoid injury to the eyes.
Chips or other debris may fly off objects when objects
are struck. Before objects are struck, ensure that no
one will be injured by flying debris.
i05768982
Mounting and Dismounting
Do not climb on the engine or the engine
aftertreatment system. The engine and
aftertreatment system have not been designed with
mounting or dismounting locations.
Refer to the OEM for the location of foot and hand
holds for your specific application.
i04112191
High Pressure Fuel Lines
Contact with high pressure fuel may cause fluid
penetration and burn hazards. High pressure fuel
spray may cause a fire hazard. Failure to follow
these inspection, maintenance and service in-
structions may cause personal injury or death.
SEBU8726-03
13
Safety Section
Crushing Prevention and Cutting Prevention
This document has been printed from SPI2. NOT FOR RESALE