Operation and maintenance manual

Throttle Control Option
Note: Some application the maximum throttle
position can before the throttle peddle has reached
the stop. The actual maximum position of the throttle
must be known before starting the procedure. With
the known maximum position the middle position of
the throttle can be calculated. The throttle must be
positioned in the required positions for the prescribed
period to perform an engine oil service reset.
1. With the engine stopped. Turn the keyswitch to the
ON position, and wait 15 seconds, but not more
than 20 seconds. Go to step 2.
2. Move the throttle to the maximum position for more
than 15 seconds, but less than 20 seconds.
3. Return throttle to zero position for more than 15
seconds, but less than 20 seconds.
4. Move the throttle to the maximum position for more
than 15 seconds, but less than 20 seconds.
5. Return throttle to zero position for more than 15
seconds, but less than 20 seconds.
6. Move the throttle to the middle position for more
than 15 seconds, but less than 20 seconds.
Return the throttle to zero position. The engine oil
service reset procedure is complete.
7. On completion of the sequence, the low oil warning
lamp will flash three times. Each flash will be for 1
second with a 1 second interval. This sequence of
flashes indicates that the warning lamp has been
reset and the engine can be started and operated
normally.
8. Turn the keyswitch to the OFF position.
9. If the procedure has been interrupted before
completion, turn the power off for 20 seconds
before starting again.
Multi-State Switch Option
1. With the engine stopped. Turn the keyswitch to the
ON position, and wait 15 seconds, but not more
than 20 seconds. Go to step 2.
2. Turn the multi-state switch to position 1 for more
than 15 seconds, but less than 20 seconds.
3. Return the multi-state switch to position 0 for more
than 15 seconds, but less than 20 seconds.
4. Turn the multi-state switch to position 1 for more
than 15 seconds, but less than 20 seconds.
5. Return the multi-state switch to position 0 for more
than 15 seconds, but less than 20 seconds
6. Turn the multi-state switch to position 1 for more
than 15 seconds, but less than 20 seconds.
Return the multi-state switch to position 0. The
engine oil service reset procedure is complete.
7. On completion of the sequence, the low oil warning
lamp will flash three times. Each flash will be for 1
second with a 1 second interval. This sequence of
flashes indicates that the warning lamp has been
reset and the engine can be started and operated
normally.
8. Turn the keyswitch to the OFF position.
9. If the procedure has been interrupted before
completion, turn the power off for 20 seconds
before starting again.
Perkins Electronic Service Tool
The Perkins electronic service tool can be used to
reset the oil service indicator. Connect the electronic
service tool and use the menu to reset the oil service
reset procedure.
i04401341
Fan Clearance - Check
There are different types of cooling systems. Refer to
the OEM for information on clearance for the fan.
Ensure that the engine is stopped. Ensure that the
battery disconnect switch is in the OFF position.
Ensure that the cooling system is full. The clearance
between the cover (1) and the fan (2) will require
checking. The gap (A) between the edge of the cover
and the tip of the fan blade must be checked in four
equally spaced positions.
SEBU8726-03
103
Maintenance Section
Fan Clearance - Check
This document has been printed from SPI2. NOT FOR RESALE