Disassembly and assembly

10. Connect the upper radiator hose to water
temperature regulator housing (1) and tighten the
hose clamps securely.
11. Connect the wiring harness to coolant
temperature sensor (4). Slide the locking tab into
the locked position.
12. Install the wastegate solenoid. Refer to
Disassembly and Assembly, “Wastegate Solenoid
- Remove and Install” for the correct procedure.
13. Fill the cooling system to the correct level. Refer
to Operation and Maintenance Manual, “Cooling
System Coolant - Check” and Operation and
Maintenance Manual, “Cooling System Coolant -
Change” for the correct filling procedures.
i05270798
Engine Lifting Bracket -
Remove
Removal Procedure
Follow the removal procedure for the configuration of
engine lifting brackets that are installed.
Option 1
Illustration 167 g03001156
View of the engine lifting bracket on the front of the
engine
Illustration 168 g03001176
View of the engine lifting brackets on the rear of the
engine
1. Remove bolts (2) from lifting bracket (1).
2. Remove lifting bracket (1) from fan drive assembly
(3).
3. Remove bolts (7) from lifting bracket (4).
4. Remove lifting bracket (4) from the cylinder head.
5. Remove bolts (6) from lifting bracket (5).
6. Remove lifting bracket (5) from the cylinder head.
98 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE